What problems will be encountered when using battery strapping machine

battery strapping machine may encounter various problems during use, which may involve equipment operation, performance, malfunctions, and other aspects. Here are some common questions and their possible causes:

1、 Operational issues

Empty hit:

Problem description: Pressing the packing button without putting in the packing tape resulted in severe wear of the tightening wheel.

Solution: Remember not to empty the bag, make sure to put it in the packing tape before each operation.

Improper selection of packing straps:

Problem description: The use of packaging belts with poor quality or recycled materials has led to increased equipment wear and tear.

Solution: Choose pure packaging tape and avoid using recycled or low-quality packaging tape.

Wrestling equipment:

Problem description: Improper operation during use resulted in equipment falling and causing damage.

Solution: Handle with care to avoid dropping the equipment.

2、 Performance issues

battery strapping machine Tightening and slipping:

Possible reasons: Tightening wheel or lower pad sticking, wear, excessive gap or thin strap, poor strap quality, excessive tightening force, etc.

Solution: Remove the waste on the tightening wheel and lower pad, replace worn parts, adjust clearances and tension, etc.

Poor welding effect:

Possible reasons: welding time too long or too short, inappropriate spacing between friction parts, worn carbon brushes of welding motors, damaged bearings, etc.

Solution: Adjust the welding time, adjust the spacing between friction parts, replace worn parts, etc.

Non fusion:

Possible reasons: Welding motor failure, welding microswitch contact failure or damage, etc.

Solution: Check and replace the faulty component to ensure proper circuit connection.

3、 Fault problem

Cassette:

Problem description: The strap is stuck in the middle of the roller or blocked by foreign objects and cannot be removed.

Solution: Disassemble the relevant components, remove the stuck object, and assemble and restore it in the correct way.

Not automatically taken out:

Possible reasons: There are foreign objects inside the machine, the thickness of the packing tape is not appropriate, the potentiometer for controlling the length of the conveyor tape is at zero, the threading is incorrect, and the electromagnet is not working properly.

Solution: Clean the inside of the machine, adjust the thickness of the packing tape and the length control potentiometer of the conveyor tape, correctly thread the tape, check and repair the electromagnet, etc.

Tightly tied without cutting the tape:

Possible reasons: The tension adjustment is too tight, there is oil on the slipping plate or belt, the belt is too tight, the belt is too thin, or the gap between the unwinding rollers is too large.

Solution: Adjust the tightness, remove oil stains, adjust the gap between the belt and roller, etc.

contact us for a solution  

whatsapp:+8613821200259

Email: efren_y@163.com